11.03.2017, 10:54
Dear lcn community,
I would like to extend my installation with extra room temperature sensors. I bought couple of lcn-ts and lcn-iv to mont them but I met an trouble with reading data. It seems that both temperatures are written to one variable. When I hold sensor in hand I see that temperature gets higher but then gets overriden by second sensor. I checked different ways of wirings as shown in tdi doc, but none of these works for me. Is there any specific wiring to be made or lcn module programming which needs to be made? Is such connection is even supported? I know for lcn-bmi there are addresses, but I didnt find anything about ts.
Kind regard,
Lukasz
I would like to extend my installation with extra room temperature sensors. I bought couple of lcn-ts and lcn-iv to mont them but I met an trouble with reading data. It seems that both temperatures are written to one variable. When I hold sensor in hand I see that temperature gets higher but then gets overriden by second sensor. I checked different ways of wirings as shown in tdi doc, but none of these works for me. Is there any specific wiring to be made or lcn module programming which needs to be made? Is such connection is even supported? I know for lcn-bmi there are addresses, but I didnt find anything about ts.
Kind regard,
Lukasz